RIP V2 Lab

how to inject default route

 

 

 

 

Basic RIP V2 Configuration in GNS3

 

What’s new in RIP version 2?

RIPv2 boasts the following enhancements:

  • Support for variable length subnet masks (VLSM) (Because of this, RIP doesn’t assume that all networks are classful.)
  • Multicast routing updates
  • Authentication with an encrypted password for routing updates

The main enhancement of RIPv2 over its ancestor is the fact that it first sends the subnet mask with the updates; hence it is considered to be a classless routing protocol in the sense that it is able to distinguish among different subnets – which is something that is not found in RIPv1.

Objective: Configuring RIP v1 on the routers to exchange routes between the routers.

Follow the below configuration or watch video tutorial at the end

rip v2 lab

On R1

router#conf t

R1(config)#Router RIP

R1(config-router)#no auto-summary

R1(config-router)#version 2

R1 (config-router)#net 1.0.0.0

R1 (config-router)#net 192.1.12.0

 

On R2

Router#conf t

R2(config)#Router RIP

R2(config-router)#no auto-summary

R2(config-router)#version 2

R2 (config-router)#net 2.0.0.0

R2 (config-router)#net 192.1.12.0

On Both Routers
• Type Show ip route
• What networks do you see listed?
• Ping your partner’s Loopback Interface address. Are you successful?

 

Video tutorial of rip v2 lab

Leave a Reply