RIP using UNICAST

RIP using UNICAST

 

 

 

 

RIP using UNICAST

Objective: Turn Spilt-Horizon back on. You would like to send Unicast updates
between R1 and R2 instead of Broadcast updates.

Turning Split Horizon Back on

On Both Routers

Rx(Config)#int s 0/0
Rx(Config-if)#ip split-horizon
Sending Unicast Updates on S 0/0 interface
On R1
R1(config)#Router rip
R1(config-router)#passive interface S 0/0
R1(config-router)#neighbor 192.1.12.2
On R2
R2(config)#Router rip
R2(config-router)#passive interface S 0/0
R2(config-router)#neighbor 192.1.12.1
• Passive interface command disables RIP from sending broadcasts over a
specific interface. The neighbor allows updates to go to specific IP
addresses. So It will disables all RIP broadcasts and only send unicast
updates to each other

 

Leave a Reply