How to Set vty lines and Privileged Access Password in Cisco Gns3

ccna ccnp gns3

 

 

 

 

How to set vty lines password

 

Virtual terminal lines (vty) are used to allow remote access to the router (by telneting through its interfaces). The router has five virtual terminal lines by default.

Steps:

Router(config)# line vty 0 4

Router(config-line)# password techtip

 

Setting Privileged Access Password

 

To set a local password to control access to various privilege levels, use the enable password global configuration command. Use the no form of this command to remove the password requirement.

 

An enable password is defined as follows:

  • Must contain from 1 to 25 uppercase and lowercase alphanumeric characters.
  • Must not have a number as the first character.
  • Can have leading spaces, but they are ignored. However, intermediate and trailing spaces are recognized.

Router(config)# enable password techtip

2 thoughts on “How to Set vty lines and Privileged Access Password in Cisco Gns3”

  1. Thanks for showing interest in our article ,and as per your need enter #write or #wr to save your configuration,hope this helps,comment if you need any more help

Leave a Reply to jason Cancel reply