CCNA Lab Two Routers Same network

Screenshot (8)

 

 

 

 

 

 

 

 

 

 

CCNA Lab Two Routers Same network

 

 

This tutorial is all about configuration of router to connect in same  network.
For example here i have taken two ip from same network 10.0.0.0/8. First ip is 10.0.0.1 from and other ip 10.0.0.2.Now these ip cannot ping each other  because nothing is configured on any router ,so how will the routers know that we have to connect the other one which is also in the same network.So our aim is to make routers understand that  you belong to the same network.To do that follow the video tutorial given at the end or follow the steps below:

Now go to router and type the below code to assign ip address on router interface and up it ports

R1

Router>enable

Router#configure terminal

Enter configuration commands, one per line. End with CNTL/Z.

Router(config)#interface fa0/0

Router(config-if)#ip address 10.0.0.1 255.0.0.0

Router(config-if)#no shutdown

R2

Router>enable

Router#configure terminal

Enter configuration commands, one per line. End with CNTL/Z.

Router(config)#interface fa0/0

Router(config-if)#ip address 10.0.0.2 255.0.0.0

Router(config-if)#no shutdown

That is it,the two routers must have connection to each other and to check connectivity

R1# ping 10.0.0.2

R2#ping 10.0.0.1

Pinging 10.0.0.1 with 32 bytes of data:

Request timed out.
Reply from 10.0.0.2: bytes=32 time=0ms TTL=127
Reply from 10.0.0.2: bytes=32 time=15ms TTL=127
Reply from 10.0.0.2: bytes=32 time=15ms TTL=127

Ping statistics for 10.0.0.2:
Packets: Sent = 4, Received = 3, Lost = 1 (25% loss),
Approximate round trip times in milli-seconds:
Minimum = 0ms, Maximum = 15ms, Average = 10ms

Hence you can see both pc can now having communicating with each other.

,do tell in the comments what you got or if you need any help

Video Tutorial

Leave a Reply